Bartscher 100211 Mode D'emploi page 27

Possible settings:
Upper and lower heater = BREAD/TOAST,
Upper heater = BUNS
STBY = standby
•
Next, to test the unit, place two slices of bread on the guide shelf. Faster belt speed
will result in lighter toasting, and slower belt speed will result in darker toasting.
•
After toasting, the bread is dispensed depending on the setup either at the front or
rear of the unit.
NOTE!
For toasting moister products, such as English muffins, rye bread or whole-grain
bread, the belt should be set at a slower speed by turning the belt speed regulator
to a higher setting (turn clockwise).
•
Best results can be achieved by selecting an average (3-4) conveyor belt speed.
•
Products to be toasted may also be placed directly on the shelf. If the unit is used in
this way, the guide shelf should be placed at the very back of the unit.
•
If the toaster is not in use, to save energy it may be placed in „STBY" mode. The
toaster will use only 25% of its typical energy use.
NOTE!
To place the toaster in full readiness mode, turn the On/Off switch to
BREAD/TOAST or BUNS. The unit is ready after 5 minutes to begin toasting.
- 26 -