Accessing Filter Cartridges - Sunrise spas Inspiration S101 L Guide D'utilisation

ACCESSING FILTER CARTRIDGES

Our various spa models use different filter systems depending on the spa design. Identify which filter system is in
your spa and check (√) it off for future reference.
Ultraskim 75 with Vane Top and Telescoping Weir
Single cartridge, vertically mounted, 75 sq. ft. 14 13/16"(37.6cm) high (part #PLBS75)
2019 European Inspiration Spas Owner's Manual
1. Shut off your spa at the Ground Fault Circuit
Interrupter(GFCI) or Residual Current Detector(RCD)
2. In the perimeter of the vane top, remove the phillips
screw that holds the top in place. Turn the top to
unlock it from the filter body. Note: The top cap is
press fit only. Set vane top aside.
3. Remove telescoping weir that is held in place by
the vane top.
4. Remove the debris basket by grasping the inner tab.
Dump any debris and set aside.
5. Pull cartridge straight up and out of the filter body.
6. Examine, clean, rotate or replace the cartridge as
necessary.
7.
Reverse the procedure to install new or cleaned
cartridge.
DOC: OM-INSPIRATION-19E
67