Cameo ZENIT B200 Manuel D'utilisation page 10

SETTING STANDALONE MODE
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "Stand Alone" (observe arrow) and
confirm with ENTER. In the sub-menu you can now select from the stand-alone modes "Auto", "Colour Macro", "Static", "Tunable White",
and "User Colour" with UP and DOWN. Confirm your selection with ENTER.
---------------- Menu ----------------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
AUTO MODE (programme 1 - programme 6)
The 6 different auto-programmes each comprise non-editable colour-change sequences. Brightness and speed are independently adjustable.
Select auto mode as per the procedure previously described in SETTING STAND ALONE MODE and confirm with ENTER. Using the UP and DOWN
controls, now select one of the 6 auto-programmes (observe arrow) and confirm with ENTER. To adjust brightness, use the UP and DOWN
controls to select the menu item "Dim", and confirm with ENTER, then use the UP and DOWN controls to select the desired value between 000
and 255. Confirm with ENTER. To adjust the run speed, select the menu item "Speed", confirm with ENTER, and then select the desired value
between 001 and 100. Confirm with ENTER. Press MODE four times to return to the main display (Mode Auto).
----------- Stand Alone -----------
Auto
Colour Macro
Static
Tunable White
User Colour
COLOUR MACROS (Colour Macro)
15 different preset colour macros are available. Select colour macro mode as per the procedure previously described in SETTING OPERATION
MODE and confirm with ENTER. Using the UP and DOWN controls, now select the desired colour preset (observe arrow) and confirm with ENTER
(Colour Off = blackout). The display will show a three-digit number field and you can use the UP and DOWN controls to set the desired bright-
ness between 000 and 100. Confirm with ENTER. Press MODE three times to return to the main display (colour macro mode).
----------- Stand Alone -----------
Auto
Colour Macro
Static
Tunable White
User Colour
STATIC MODE (Static)
The static mode allows the Dimmer, Strobe, R, G, B, W to be adjusted directly on the device with values between 000 and 255, in a similar
way to with a DMX controller. In this way, an individual scene can be created without an additional DMX controller. Select static mode as per
the procedure previously described in SETTING OPERATION MODE and confirm with ENTER. Using the UP and DOWN controls, now select
the menu item that you wish to edit (observe arrow) and confirm with ENTER. The display will show a three-digit number field and you can
use the UP and DOWN controls to configure the desired value between 000 and 255. Confirm with ENTER. Press MODE three times to return
to the main display (static mode).
----------- Stand Alone -----------
Auto
Colour Macro
Static
Tunable White
User Colour
10
----------------- Mode ----------------
Auto
Colour Macro
Static
Tunable White
User Colour
---------------- Auto ----------------
Program 1
Program 2
Program 3
Program 4
Program 5
Program 6
--------- Colour Macro ---------
Colour Off
Red <100>
Amber <100>
Yellow Warm <100>
Yellow <100>
Green <100>
Turquoise <100>
Cyan <100>
---------------- Static ----------------
Dimmer <255>
Strobe <255>
Red <255>
Green <255>
Blue <255>
White <255>
---------- Programme x ----------
Dim <255>
Speed <100>
Dim Speed
000 001
– –
255 100
Blue <100>
Lavender <100>
Mauve <100>
Magenta <100>
Pink <100>
Warm White <100>
White <100>
Cold White <100>
000
–
Mode
Static
255
001
–
Mode
Auto
100
001
–
Mode
Colour Macro
100