Buzzer Setting - Panasonic EYFPA1J Instructions D'utilisation

Buzzer setting

EN EN
You can select from three buzzer modes.
1. Set the tool to setting configuration mode.
(See page 13.)
. Press the A button once.
The current setting value will be displayed.
3. Press the
desired value.
Display
b0
b1 Buzzer accompanying green indicator
b Buzzer accompanying red indicator
4. Press the OK button to accept the new
setting.
NOTE:
The tool ships with the buzzer mode set
to b0 by default.
Radio signal range limitation
function on/off setting
(EYFPA1JR,
EYFNA1CR, EYFNA1JR, EYFNA1PR)
1. Set the tool to configuration mode.
(See page 13.)
. Press the C button three times.
The control panel will begin flashing.
Display: The letter "F" flashes on and off.
Battery indication lamp: The upper and low-
er bars of the battery flash on and off.
[Fig.25]
3. Press the C button again.
Radio signal range limitation function on/
off setting value will be displayed.
[Fig.26]
4. Press the
signal range limitation function on/off.
Radio signal
Display range limitation
function mode
C0 OFF
C1 ON
and buttons to set the
Function
No buzzer
and buttons to set radio
Status
Tool is operational in the
absence of communica-
tions with the Assembly
Qualifier.
Tool is not operational
in the absence of com-
munications with the As-
sembly Qualifier.
Factory settings
Radio signal range limitation function
setting: C0 (OFF)
NOTE:
For more information about how to reg-
ister the tool and Assembly Qualifier,
see the Assembly Qualifier instruction
manual.
LED light setting
You can select from two LED light modes.
1. Set the tool to setting configuration mode.
(See page 13.)
. Press the B button once.
The current setting value will be displayed.
3. Press the
desired value.
Display
d1 Linked to LED light button
d Linked to trigger switch operation
4. Press the OK button to accept the new
setting.
NOTE:
The tool ships with the LED light mode
set to d1 by default.
Speed control function
The speed (RPM) can be changed with the
amount of depression of the trigger.
1. Set the tool to setting configuration mode.
(See page 13.)
. Press the B button three times.
The setting value will be displayed.
3. Press the
desired value.
Operation
P0
P1
4. Press the OK button to accept the new set-
ting.
- 16 -
and buttons to set the
Function
and buttons to set the
Function
Speed control ON
Speed control OFF