Meisselhammer_380381.book Seite 22 Montag, 23. Januar 2017 12:59 12
GB
Changing the rotation direction
NOTICE! Risk of damage to the unit!
Only use the rotation direction switch when
the device is at a standstill.
– To drill and screw screws into place, press the
rotation direction switch (3) to the left (rotation in
clockwise direction).
– To remove screws, press the rotation direction
switch to the right (rotation in an anti-clockwise
direction).
Check before switching on!
Check to make sure the unit is in a safe operating
condition:
– Check to make sure there are no visible defects.
– Check to make sure all unit components are cor-
rectly mounted.
Switching on and off
– To start the tool turning, press the On/Off
switch (5).
– To operate permanently, press the locking but-
ton (4) whilst holding down the the On/Off
switch.
– Press the On/Off switch again and release to
release the lock.
– To switch the unit off, release the On/Off switch
[5].
Note: The revolution speed of the device
can be varied by applying different pres-
sures to the On/Off switch.
Drilling
DANGER! Risk of injury! Never hold the
work piece that you are working with in your
hand, on your lap, or against other body
parts.
Error/Fault
Tool holder does not turn.
Tool holder is turning, but the de-
vice is not drilling.
No hammer drilling function.
No chasing function.
If you can't fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred.
Disposal
Disposal of the appliance
Appliances which are labelled with the adja-
cent symbol must not be disposed of in
household waste. You must dispose of such
old electrical and electronic equipment sep-
arately.
22
– Hold the device straight and drill with even pres-
sure.
Cleaning
Cleaning and maintenance at a glance
Regularly and according to the operating condi-
tions
What?
Clean the ventilation slots
of the motor to remove
dust.
Clean the device.
Troubleshooting
What to do when something doesn't work...
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the
vendor. You will save yourself a lot of trouble and
possibly money too.
Cause
No power supply?
Is the device defective?
Revolution direction set incorrect-
ly?
Mode switch is not set correctly? Put the switch to position [
– Please check with your local authority about the
possibilities for correct disposal.
Through separate disposal you send old equipment
for recycling or for other forms of re-use. You will
thus help to avoid in some cases that damaging
material gets into the environment.
Disposal of the packaging
The packaging consists of cardboard and
correspondingly marked plastics that can
be recycled.
– Make these materials available for
recycling.
NOTICE! Risk of damage to the unit!
Never use the drill for chasing or to expand
drilled holes.
Always use a drill appropriate to the mate-
rial.
How?
Use a vacuum, cleaning
brush or paint brush.
Wipe the unit with a damp
cloth.
DANGER! Exercise caution – risk of
injury! Unprofessional repairs may mean
that your unit will no longer operate safely.
This endangers you and your environment.
Remedy
Check the cable, plug, and the fuse.
Contact your local vendor.
Switch the rotation direction reversing
switch.
Set the switch to position [
].
] or [
].