S&P TOWER-2000 PTC Notice D'installation Et D'utilisation page 12

 You can control the ceramic heater through the control panel (Fig.1B) or with the
remote control (Fig.1G)
 CONTROLS
POWER
The product has two on and off switches. One is generally located at the base of the
appliance (Fig.1F) and the other in the control panel/ remote control. To operate the
device, both must be on.
IMPORTANT: To preserve the life of the heating element (Fig. 1C), the appliance
incorporates an automatic cooling system, so that when you disconnect the
appliance using the POWER button of the control panel/ remote control, the fan
continues to run for 30 seconds.
Do not unplug the heater by directly acting on the main foot switch (Fig.1 F) or
pulling the power cable.
MODE
You can select up to 3 different operating modes:
 FAN mode:
 LOW-HIGH Mode:
 AUTO Mode:
Note : The LCD screen shows the real temperature of the room (ROOM TEMPERATURE)
TIMER
You can set the heater operating time in fractions of ½ hour, upto a total of 8 hours.
Once the time has elapsed, the heater will stop automatically.
OSC
You can increase the area of air projection (hot/cold) oscillating the appliance.
Note: Make sure the power cable is not twisted between the base and the oscillating
body.
Fan cold air
Manual selection of the heater power
Low : 1.000 W
High : 2.000 W
The heater works to continuously selected power, regardles of
the room temperature.
The power heater is self-adjusted automatically depending on
the room temperature.
When you select this operating mode, using the +/- keys can be
programmed (SET) the desired temperature in the room (+15 ~
+35ºC).
When the room temperature approaches the comfort
temperature programmed by the user, the heater will
automatically regulate the power while constantly maintaining
temperature in the room. Remember that the comfort
temperature is between 21-22ºC.
12