LIFT SYSTEM INSTALLATION
NOTE: The lift system is an exterior-rated lift system. Refer to the online compatibility database
located at www.pridemobility.com for information concerning lift system/vehicle compatibility,
or contact your authorized Pride Provider.
WARNING! The lift system should be installed only by an authorized Pride Provider or service technician.
WARNING! At least two people should lift the lift system into the rear of the vehicle. Use proper lifting techniques
and avoid lifting beyond your physical capability.
WARNING! Avoid pinch points! Do not hold the lift frame by the pivot points when installing the lift system.
NOTE: Footprint the mounting area along with the lift and mobility device to make sure all
clearances pass above and below vehicle without any interference before starting installation.
NOTE: Use only the supplied hardware to install the lift system.
NOTE: To preserve vehicle-system data, the vehicle's power system may need to be connected
to an alternate power source prior to battery removal. Refer to the vehicle's owner's manual for
information on proper battery-disconnection instructions.
Follow these steps for installation:
1. Install the lift system securement system to the vehicle.
NOTE: Securement systems vary depending on vehicle manufacturer. Pride recommends use of
only the securement system provided with the lift and that you follow any instructions provided
by the manufacturer for installation.
2. Connect the lift system to a power source. See "Wiring Harness Installation."
3. Ensure that all mounting hardware is fully tightened and all required clearances have been achieved.
NOTE: The lift system may include an optional set of L-Base extensions. For information on
L-base extension installation, refer to the supplemental instructions or contact your authorized
Pride Provider.
NOTE: The lift system is equipped with a power base, which is an automated device designed to
rotate the boom arm left and right.
Commander Series
I I I . I N S TA L L AT I O N
www.pridemobility.com
9