Pride Mobility Products Commander 400 Série Mode D'emploi page 10

BOOM-ARM ADJUSTMENT
The boom-arm can be adjusted for your convenience.
See figure 1.
To raise or lower the upper post:
1. Remove the nut and bolt from the upper post. See
figure 1.
2. Raise or lower the upper post to the desired position,
matching the adjustment holes of the upper post
with the adjustment holes of the lower post.
3. Reinstall the bolt through the adjustment hole and
secure it with the nut.
Lift System:
The Commander 450 is available in 2-axis or 3-axis
models. The hand control has 6 buttons and is designed
to control movement on all 3 axes. The orange button
will not operate on 2-axis lift systems.
1. Rotate (Left and Right)
2. Boom Extension (In and Out) (3-axis system only)
3. Lifting Strap (Up and Down)
NOTE: The angle of the boom are can be adjusted
to accommodate certain height limitations. See
figure 4.
NOTE: Do not force the threaded bolt into the
adjustment hole.
To secure the base:
Four nuts and four bolts are needed to firmly secure
the lift system onto the base of your choice. There are
four securement bolt holes located on the L-base. See
figure 2.
Two bolts will be installed beneath the shroud of the
power base. See figure 3.
10
I I I . I N S TA L L AT I O N
www.pridemobility.com
BOOM ARM
UPPER POST
BOLT
Figure 1. Upper Post Adjustment
BOOM EXTENSION
LIFTING
STRAP
UPPER POST
L-BASE CAP
L-BASE
Figure 2. Fully Assembled Lift System
SECUREMENT BOLTS
SECUREMENT
BOLT HOLE
SECUREMENT BOLT
HOLES (UNDER SHROUD)
Figure 3. Power Base
NUT
LOWER POST
SECUREMENT
BOLT HOLE
SECUREMENT BOLTS
SECUREMENT
BOLT HOLE
Commander Series