Hand Control Operation - Pride Mobility Products Commander 400 Série Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

POWER SWITCH OPERATION
The lift systems is equipped with an ON/OFF swtich that
enables/disables operation. Toggle the ON/OFF switch
to the "I" position to turn the power on; to the "O" position
to turn the power off. See figure 6.
NOTE: The ON/OFF switch also functions as the
circuit breaker reset button. See figure 6.

HAND CONTROL OPERATION

The hand control for the lift system operates the arm
in six directions: up/down, rotate left/right and in/out.
Press and hold the appropriate button until the desired
position is obtained. See figure 7.
NOTE: Store the hand control in the hand control
bracket (located on the boom) after operation and
during storage.
LIFTING THE MOBILITY PRODUCT
WARNING! Before operating the lift system for the
first time, be absolutely certain you have the proper
docking device for your mobility product installed.
WARNING! Always operate the lift and mobility
device being lifted on a flat, level surface.
1. Prepare your mobility product for transport. Ensure
that the power is off and properly secure the batteries.
You may also need to lower the tiller and/or remove
the seat.
2. Position your mobility product on the ground be-
hind the installed lift. Be sure that there is ample
space between the mobility product and the vehicle
bumper to insure that the mobility product will not hit
the bumper while being raised. If the mobility prod-
uct is too far from the vehicle's bmper, the mobility
product will be dragged when attempting to lift it.
3. Position the boom-arm over the mobility product.
4. Operate the lift in the downward direction. The lift
strap should drop staright down to the T-bar or dock-
ing device.
WARNING! Inspect the lift strap before each use for
twisting, fraying, signs of wear, loose parts, damage
or debris. If you discover a problem, contact your
authorized Pride Provider for maintenance and
repair.
WARNING! Avoid unloading into vehicular traffic.
NOTE: Keep tension on the lifting strap with your
free hand when lowering the boom-arm.
Commander Series
I V. O P E R AT I O N
www.pridemobility.com
INTERRUPTEUR
ON/OFF
ON
OFF
Figure 6. ON/OFF Switch
ROTATE LEFT
UP
DOWN
Figure 7. Hand Control
ROTATE RIGHT
BOOM OUT*
BOOM IN*
* NO FUNCTION
ON 2-AXIS LIFT
13

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Commander 400Commander 450

Table des Matières