Special Operation - Mitsubishi PAR-SL100A-E Manuel D'utilisation

5. Special Operation

F
9
A
Fig. 5-1
Fig. 5-2
Some functions cannot be operated depending on the air
conditioner.
Confi rm whether the air conditioner supports each func-
tion, and then operate the air conditioner.
D
<Switching to the special operation mode>
1. Press the
• If the weekly timer is enabled, press the
9 to disable the timer. (
2. Press the
• The Function setting screen will be displayed and the
1
function No. A will blink. (Fig. 5-1)
<Transmitting the settings>
• When you perform each operation,
controller display blinks to indicate that the
4
ton 3 must be pressed to transmit the settings. Point
2
the transmission area of the wireless remote controller
3
towards the receiver on the indoor unit and press the
5
indoor unit beeps at this time.
<Exiting the special operation mode>
1. While the operation screen for each function is displayed,
press the
• The Function setting screen will be displayed and the
function No. A will blink. (Fig. 5-1)
2. Press the
• The display returns to the normal screen.
5.1. Setting the fi xed airfl ow direction
1. In the Function setting screen, press the
select function No. "2".
2. Press the
• The vane number B blinks. (Fig. 5-2)
3. Press the
• For information about the vane numbers, refer to the
indoor unit operation manual.
4. Press the
• The airfl ow direction setting C blinks. (Fig. 5-2)
5. Press the
which you want to fi x the vane.
C
Step 1
B
Draft reduction
(No display)
6. Press the
Note:
Draft reduction
The airfl ow direction for this setting is more horizontal than
the airfl ow direction for the "Step 1" setting in order to re-
duce a drafty feeling. The draft reduction can be set for
only 1 vane. The setting is enabled only for the last vane
that was set.
button 1 to stop the air conditioner.
button 2.
button 3 to transmit the settings. Confi rm that the
button 2 or the
button 2.
button 3.
button 4 to select the vane number.
button 3.
button 4 to select the airfl ow direction at
Step 2 Step 3
No setting
button 3 to transmit the settings.
button
F disappears.)
D on the remote
but-
button 5.
button 4 and
Step 4 Step 5
15