Marquant 880137 Mode D'emploi page 37

The troubleshooting chart will help you identify the causes of common problems and how they can be
rectified. Contact your dealer if you cannot rectify the problem by using the troubleshooting chart.
PROBLEM/ERROR CODE
Nothing is displayed
•
when you press the
power switch, or the
battery indicator
flashes
E1: The air pressure
•
does not rise
correctly
•
• E3: The inflation
pressure is too high
• E2, E4: Movement
during the measuring
The battery indicator is
displayed
Unreasonably high value is
shown for systolic or diastolic
pressure
Unreasonably low value is
shown for systolic or diastolic
pressure
Guidelines and manufacturer's certificate concerning electromagnetic radiation
The blood pressure monitor is intended to be used in electromagnetic environments in accordance with
the specifications below. It is incumbent on the customer or the person using the blood pressure monitor
to ensure that the electromagnetic environment in which it is used complies with these specifications.
Emission test
Radio frequency
radiation CISPR 11
Radio frequency
radiation CISPR 11
Overtones IEC 61000-
3-2
Voltage fluctuation/
flicker IEC 61000-3-3
Guidelines and manufacturer's certificate concerning electromagnetic immunity
The blood pressure monitor is intended to be used in electromagnetic environments in accordance with
the specifications below. It is uncumbent on the customer or the person using the blood pressure monitor
to ensure that the electromagnetic environment in which it is used complies with these specifications.
Immunity test
Electrostatic discharge ±6 kV on contact
TROUBLESHOOTING
POSSIBLE CAUSE
No batteries
•
The batteries are
•
discharged.
The batteries have the
•
wrong polarity
The blood pressure
•
sleeve is leaking
• The arm or body moved
during the measurement
• The batteries are
discharged.
• The sleeve was held
lower than the heart
• The sleeve was not fitted
properly
You moved or spoke
•
during the measurement
The sleeve was held
•
higher than the heart
You moved or spoke
•
during the measurement
Compliance Guidelines for electromagnetic environment
Group 1 Radio frequency energy is only used in the blood pressure
monitor for the internal functions in the product. The emitted
radio frequency radiation is therefore very low and the
probability of it causing interference in nearby electronic
equipment is low.
Class B The blood pressure monitor is suitable for use in apartments
and similar environments, directly connected to low voltage
networks for the distribution of electricity to apartment
Not applicable
buildings.
Not applicable
Test level as per Compliance level
IEC 60601
ENGLISH
ACTION
•
•
•
•
•
•
•
•
Guidelines for electromagnetic
environment
±6 kV on contact The floor surface should consist of
37
Insert the batteries
Insert new batteries
Insert the batteries with the correct
polarity
Replace the sleeve
Contact your dealer
Sit still in the correct posture and
measure again
Insert new batteries
Stay in the correct posture and
measure again.