EUROM INDEPEND 800 Manuel D'instruction page 41

5 – Filter fuel tank
a) Remove the tank cap and the filter
b) Wash the filter in a solvent; if it is damaged, it must be
replaced.
c) Rub the filter dry and replace it.
Warning: Ensure you close the fuel cap.
6 – Spark arrester
Warning:
 During and immediately after operation, the engine and
exhaust are very hot! Do not touch them with your bare
skin exposed or with clothing. Allow the device to cool
down before performing inspections or repairs!
f) Remove the rear panel by unscrewing the four screws.
g) Loosen the clamp using a screwdriver.
h) Pull the spark arrester from the exhaust (if necessary,
use the flat head of a screwdriver to dislodge it
carefully).
i) Remove the carbon build-up from the spark arrester
using a brush.
j) Replace the spark arrester and the rear panel in their
proper places.
Troubleshooting
1 – The engine will not start
 No fuel is being sent to the carburettor.
There is no fuel in the tank – add fuel.
-
There is fuel in the tank – turn the fuel cock and the venting button to the
-
"ON" position.
The fuel line is blocked – clean it.
-
The carburettor is blocked – clean it.
-
 The engine does not have sufficient oil.
Add oil.
-
 Problems with the ignition system: not enough sparks.
The spark plug is dirty or wet – clean and/or dry it.
-
A problem with the ignition system – consult your dealer.
-
41