Zodiac Jandy Pro ePump Série Manuel D'installation Et De Fonctionnement page 22

Page 22
ENGLISH
7. If the pump is located above the water level of the
pool, remove the lid and fill the basket with water
before starting the pump.
8. To help prevent an air leak into the system, remove
any debris around the lid seal seat.
9. Hand-tighten the lid to make an air tight seal. Do
not use any tools to tighten the lid.
10. Open the pressure release valve on the filter and
make sure it is clean and ready for operation.
11. Have a qualified service technician or electrician
properly connect the electrical wiring at the pump
motor.
12. Turn on the electrical power to the pump motor
using your controller and check the system for
normal operation.
NOTE For instructions on operating the controller, refer
to the appropriate manual for your controller:
the ePump Controller Owner's Manual,
H0311200, the AquaLink
6593, the AquaLink PDA Owner's Manual,
H0572300, or the AquaLink Z4 Controller
Owner's Manual, H0386600.
13. Once all the air has left the filter, close the
pressure relief valve.
Jandy Pro Series ePump™ Series Pump | Installation and Operation Manual
®
RS Owner's Manual,
®