Service Information - Black & Decker MATRIX BDCMTTS Mode D'emploi

Module de d'ebouteuse

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

• Start the motor and gradually lower the saw until its shoe rests flat on the material to be cut.

Advance saw along the cutting line until cut is completed.

• Release trigger and allow blade to stop completely before withdrawing the blade from the material.

• When starting each new cut, repeat as above.

Problem

• Unit will not start.

For assistance with your product, visit our website www.blackanddecker.com for the location

of the service center nearest you or call the BLACK+DECKER help line at 1-800-544-6986.

NOTE: Refer to Power Unit instruction manual for troubleshooting solutions regarding opera-

tion of the Power Unit.

MAINTENANCE

Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool;

never immerse any part of the tool into a liquid.

IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and

adjustment (other than those listed in this manual) should be performed by authorized service

centers or other qualified service personnel, always using identical replacement parts.

ACCESSORIES

WARNING:

The use of any accessory not recommended for use with this tool could be hazardous.

Recommended accessories for use with your tool are available from your local dealer or authorized

service center. If you need assistance regarding accessories, please call: 1-800-544-6986.

This device complies with part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this unit not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment. This Class B digital

apparatus complies with Canadian ICES-003.