Description; Items Supplied - Hilti PRM 15 Mode D'emploi

Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the machine. Make a note
of this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.

2 Description

2.1 Use of the product as directed
The Hilti PRM 15 machine receiver is an electronic laser receiver that is capable of receiving and indicating the position
of the beam from a rotating laser. When in use, the magnetic holder can be used to attach the receiver to a steel
surface, such as the arm of a mechanical excavator. After switching on, the tool provides a visual indication of the
pre-set laser reference plane relative to the position of the excavator bucket.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
Take the influences of the surrounding area into account. Do not use the power tool or appliance where there is a risk
of fire or explosion.
Do not tamper with the tool or make modifications to it.
2.2 Features
The receiver features a long receiving window for 360 degree laser reception, which increases the working area
and range. The bright LED display provides a clear indication. The reinforced polycarbonate casing increases the
ruggedness of the tool and helps to ensure a long lifetime. The tool uses rechargeable NiMH batteries.

2.3 Items supplied

1 PRM 15 machine receiver
1 Operating instructions
1 PRMA 70 magnetic holder
1 PRA 85 AC adapter
1 Manufacturer's certificate
2.4 LED indication after setting
Setting the pre-set level shift
Setting the pre-set level sensitivity
Setting the plumb indication
NOTE
The currently selected operating mode can be shown simply by pressing the button. Selection mode can be accessed
by pressing the button repeatedly.
Type:
Generation: 01
Serial no.:
Standard setting (pre-set level is in the middle of the receiving area): The
green pre-set level LEDs light for 1 second.
Excavator mode (pre-set level is at the top edge of the receiving area):
Two red LEDs of the upper arrow light for 1 second.
Fine mode: The green pre-set level LEDs light for 1 second.
Standard mode: The green pre-set level LEDs and one red LED for each
arrow light for 1 second.
Coarse mode: The green pre-set level LEDs and all red LEDs for the ar-
rows light for 1 second.
Plumb indication is OFF: The green pre-set level LEDs light constantly for
2 seconds.
Plumb indication is ON: Two red LEDs for each of the arrows blink altern-
ately for 2 seconds.
en
11