Connect Gas Supply - Bosch RGM8058UC Manuel D'installation

Installing the Bracket with Recess Depth over 24"
If the depth is more than 24" you can choose to install
the range top against the wall as in the previous
procedure and let the control panel go inside the
furniture. Or you can decide to align the control panel
with the rear side of the furniture and have a clearance
on the back part between the appliance and the wall, so:
Measure the width of the slot for the appliance.
1.
Divide the measurement in two and trace the midline
2.
on the furniture's floor.
Measure from front side of the furniture 3" (about
3.
76 mm) and trace a line perpendicular to the midline.
Put the bracket approximately as in the figure below, in
4.
the middle of the two lines (since it's not necessary to
be more precise because the slot in the range top's
floor provides enough clearance) and trace the center
of the bracket's holes or fix it directly with the screws.

Connect Gas Supply

The appliance is shipped from the factory for use with
natural gas at a pressure of 5" of the water column.
When checking for proper operation of the regulator, the
inlet pressure must be at least 1" greater than the
operating (manifold) pressure above. When used with
natural gas, the pressure supplied to the regulator must
be between 6" and 10,5" of the water column.
To convert the appliance to propane gas see
"Conversion to propane gas (LPG)". A qualified
technician or installer must do the conversion.
The gas inlet to the unit is located at the right rear of the
appliance.
Install the pressure regulator (supplied with unit) to gas
inlet. Postion the gasket (supplied with unit) in between
the inlet and the regulator. Position the regulator to have
it cap D (~ Page 15) easily accessible. Turn the nut on
gas inlet to hand tighten plus 1/3 turn.
Install the gas pipe to the regulator using Teflon tape or
pipe-joint compound (resistant to propane gas and
natural gas). Turn to hand tighten plus 1/3 turn. Do not
exceed 1 turn for alignment, to prevent possible damage
to the gas pressure regulator.
Check inlet fittings and regulator for leaks.
* Attached to the appliance.
WARNING
9
Do not attempt any adjustment of the pressure
regulator, except when converting to propane.
Adjustments could lead to leaks or cause incorrect
gas pressure to the appliance.
9