Install Appliance; Connect Electrical Supply - Bosch RGM8058UC Manuel D'installation

Side and Back View Gas Rangetop Installation
Gas Location
Gas connection
A
Electrical connection
B
Connect the gas supply line to the unit pressure
regulator using a 1/2" flex gas line connector between
manual shut-off valve and pressure regulator. A metal
flex line or fixed metal pipe shall be used to connect gas
to the appliance. If a metal gas line cannot be used,
consult your local certified electrician or local electric
codes for proper grounding.
Check supply line connections for leaks using a soap
solution or non-corrosive leak detection fluid. Do not use
a flame of any sort.
WARNING
9
Install a gas shut off valve near the appliance. After
installation, it must be easily accessible in an
emergency.
Turn on gas.
1.
Apply a soap solution or non-corrosive leak detection
2.
fluid to all joints and fittings in the gas connection
between the shut-off valve and the cooktop. Include
gas fittings and joints in the cooktop if connections
may have been disturbed during installation. Bubbles
appearing around fittings and connections indicate a
leak.
If a leak appears, turn off supply line gas shut-off valve
3.
and tighten connections.
Retest for leaks by turning on the supply line gas shut-
4.
off valve. When leak check is complete (no bubbles
appear), test is complete.
Wipe off all soap solution or detection fluid residue.
5.
Important Notes for Gas Connection:
The appliance and its individual gas shutoff valve must
▯
be disconnected from the gas supply piping system
during any pressure testing of that system at test
pressures in excess of 1/2 psi (3.5kPa).
The appliance must be isolated from the gas supply
▯
piping system by closing its individual manual shut-off
valve during any pressure testing of the gas supply
piping system at test pressures equal to or less than
1/2 psi (3.5kPa).
10

Install Appliance

WARNING
9
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the OFF
position.
WARNING
9
Do not contact exposed regulator while placing
appliance in cabinetry.
Notes
The appliance must sit securely in the cut-out and
▯
must not be able to move around (e.g. during
cleaning).
To help prevent cosmetic damage place plastic
▯
shipping cover back over appliance prior to loading
into cabinetry.
If additional construction is nearby the plastic shipping
▯
cover can be used to preserve cosmetic finish.
Install the range top pushing it to the back wall.

Connect Electrical Supply

The 120 V power cord is installed on gas rangetop. Plug
the power cord into a standard 120 V wall outlet.
WARNING
9
ELECTRICAL GROUNDING INSTRUCTIONS
This appliance is equipped with a three-prong
grounding plug to protect you against the risk of
shocks and it should be plugged directly into a
properly grounded receptacle. Do not cut or remove
the grounding prong from this plug.