Campbell Hausfeld DW3130 Mode D'emploi page 9

GETTING TO KNOW YOUR UNIT
Figure 1 - Model DW3130
Components and Controls (Figure 1)
1. Work Clamp – connects to work piece.
2. Torch with .030 inch tip.
3. Power Cord – plug into 120 volt outlet.
4. Light – illuminates if thermostat has automatically shut welder off.
5. Infinite Wire Speed Control – turn clockwise to increase wire speed and counterclockwise to decrease
wire speed.
6. Off/Heat Selector - Selects welding power and turns welder on.
Four selections are possible: 1 – 2 – 3 – 4.
HEAT SELECTOR
1-2-3
4
See page 17 for supply cable replacement instructions.
CIRCUIT BREAKER OR SLOW BLOW FUSE FOR
120V MODELS
15 amp
20 amp
7
4
1
5
6
3
2