Introduction; Pack Contents; Installation - Polar T316 Mode D'emploi

Telephone Helpline: 0845 146 2887

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your POLAR product.

Pack Contents

The following is included:
• Ice Maker
• Ice scoop
• Inlet/Outlet hoses
POLAR prides itself on quality and service, ensuring that at the time of packaging the contents are supplied
fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR dealer immediately.
Note: Only use the hoses supplied with the appliance. Other hoses are not suitable and
should not be used.

Installation

Note: If the appliance has not been stored or moved in an upright position, let it stand
upright for approximately 12 hours before operation. If in doubt allow the appliance to
stand.
Remove the appliance from the packaging and remove the protective film from all surfaces.
1.
Remove the Scoop, Inlet/Outlet hoses and Sealing Washers from the ice bin.
2.
When positioning the ice maker, maintain a distance of 20cm
3.
(7 inches) between the appliance and walls or other objects for
ventilation. Increase this distance if the obstacle is a heat source.
If necessary, adjust the screw legs of the ice maker to make it
4.
level. The efficiency of the ice maker can be reduced if the
appliance is unevenly located.
Connect one end of the corrugated outlet hose to the water outlet
5.
on the rear of the ice maker.
Attach the other end of the hose to a plumbed-in stand waste
6.
pipe or container suitable for collecting waste water.
Place the sealing washers on the water inlet at the back of the ice
7.
maker and attach one end of the inlet hose.
Connect the other end of the inlet hose to the water supply.
8.
Note: Ensure the end of the drainage pipe is situated lower than the Water Outlet valve
for efficient drainage.
• Sealing washers
• Instruction manual
Water
inlet
Water
outlet
UK
Power cord
2