Panasonic TC-55GZ2000C Manuel D'utilisation page 22

Installing the remote's batteries
Hook
Note the correct
polarity (+ or -)
(AA batteries)
Caution
●
Incorrect installation may cause battery leakage and
corrosion, resulting in damage to the remote control.
Do not mix old and new batteries.
•
Do not mix different battery types (such as alkaline
•
and manganese batteries).
Do not use rechargeable (Ni-Cd) batteries.
•
● Do not burn or break batteries.
Indicator / Control panel
1 2, 3
Rear side of the TV
1 Remote Control sensor
Maximum range for remote is 7 m (23 ft) from front
of TV set
2 C.A.T.S.
(Contrast Automatic Tracking System)
3 Power LED
(On: red, Off: no light, Panel maintenance in
progress: Orange)
Depending on the ambient brightness, adjusts
the brightness of LED to easy-to-view levels
automatically.
22
English
TC-55_65GZ2000C_EN-CF_0204_0626-3.indb 22 TC-55_65GZ2000C_EN-CF_0204_0626-3.indb 22
4 Changes the input mode
5 Selects channels in sequence
6 Volume up / down
Pull open
7 Mains power On / Off switch
●
Close
●
Be sure to turn the TV off with the remote control to
perform the panel maintenance. During the panel
maintenance, LED turns to orange.
During panel maintenance, avoid touching and exerting
any pressure on the screen. (e.g. wiping the screen,
etc.)
There are two types of the maintenance as following.
4
●
5
6
7
Selects Menu and Submenu entries
(Press and hold down for MENU function)
●
Use to switch the mains power.
● To turn Off the apparatus completely, you must
unplug the power cord plug from the wall outlet.
●
[ ]: Standby / On
An image of the control panel is displayed on the
screen while in use.
Note
The TV consumes a small amount of electric energy
even when turned off.
Do not place any objects between the TV remote
control sensor and remote control.
Panel maintenance
Normal maintenance automatically starts, and it takes
approx. 10 minutes.
Regular maintenance takes approx. 80 minutes.
When regular maintenance is necessary, the
•
message appears on the screen after turning the
TV off with the remote control. Follow the on-
screen instructions.
During the panel maintenance, a white horizontal
•
line appears on the screen for a while. This is not
a malfunction.
For information about panel maintenance, refer to
[eHELP] (Search by Purpose > All settings > Picture >
Screen settings).
10/7/2019 2:23:44 PM 10/7/2019 2:23:44 PM