Brabantia D3 Notice D'utilisation page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SAUSAGE STUFFER KEBAB
1. Assemble the sausage stuffer kebab attachment according to FIGURE C.
2. Insert the assembled sausage stuffer kebab attachment (tilted towards you) into the
cutting housing (13) by turning in a anti clockwise direction until it locks into place.
3. Put the sausage casing into water and soak for 10 mins. Slowly and carefully slip it
over the sausage tube (22). Plug it in and set the speed switch to 1 or 2
4. Insert the ground meat into the cutting housing (13) using the pusher(20).
TIMERS
The count-up timer (Fig 13)
The count-up timer is especially useful to guage mixing time or when a recipe does not
specify the mixing time. You can monitor the time it takes to thoroughly mix the
ingredients, so that the next time you mix the same ingredients you can set the
count-down timer to a specific time. The count-up timer will automatically begin
counting up as soon as the Speed Control Dial is rotated from the OFF position to one of
the mixing speeds. When the Speed Control Dial is rotated back to the OFF position, the
LCD screen will display 0:00.
The count-down timer (Fig 14)
The count-down timer is expecially useful for any recipe that specifies the lentgh of time
ingredients should be mixed. For example, if a recipe reads, "beat for 3 minutes", you
can set the count-down timer to 3 minutes by pressing the"+" "-". after 3 minutes of
mixing, the lcd screen will display off, an alert will sound and the stand mixer will
automatically turn off. The Speed Control Dial must be rotated back to the OFF position
to reset the timer and continue mixing. To set the count-down timer, press the up or
down arrows until the desired mixing time is displayed on the LCD screen. Rotate the
Speed Control Dial clockwise to select the desired speed and to begin mixing. Once the
Mixer automatically turns off, the Speed Control Dial must be rotated back to the OFF
position to reset the count-down timer and continue mixing.
Fig. 13
Fig. 14

Publicité

Table des Matières
loading

Table des Matières