Brabantia D3 Notice D'utilisation page 8

MEAT GRINDER (Figure B)
1. Lift the cutting housing upward facing towards the outlet drive before using
the meat grinder.
2. Insert the worm shaft (14) (drive pins first) in the cutter housing (13). Fit the cutter
blade (15) on the shaft with the cutting edges facing upwards. (Fig . 9)
3. Place the selected hole-plate (16/17/18) over the blades ensuring that the two lugs
fit into the two cut-outs in the cutting housing. (Fig. 9)
4. Screw the ring cap nut (19) fully home on the cutting housing.(Fig.10)
5. Insert the assembled meat grinder attachment (tilted towards you) into the outlet
drive (12) and engage it fully. Return the feed tube to a vertical position by turning
to the anticlockwise direction until it stops and clicks into place. (Fig.11)
6. Place the removable tray (21) on the feed tube. (Fig.12)
CAUTION:
1. To release the cutting housing (13), press top left corner to open the cover then
press the button (11).
2. Insert pieces of meat into the feed tube piece by piece using the pusher (20),
WARNING: Never push the meat with your fingers or any other utensil.
Always use the pusher!