LiftMaster Contractor Série Guide De L'utilisateur page 6

Operation
Programming - Multi-Function Control Panel
Features
Lock
Command
LED
Service
LED
Light
LEARN
Button
LOCK LIGHT
Button Button
To Program
a Remote
Control or
Keyless Entry
Maintenance
Alert System
(MAS)
NOTE: Your remote controls will NOT work when LOCK mode is active however your keyless entry will still allow access to your garage.
Activate: Press and hold the LOCK button for 2 seconds. The command LED will flash as long as the lock feature is activated and your
handheld remote control will not operate your door at this time.
Deactivate: Press and hold the LOCK button again for 2 seconds. The command LED will stop flashing and normal operation will resume.
To change the amount of time the garage door opener lights will stay on (default time is 4-1/2 Minutes):
Press and hold the LOCK button until the garage door opener lights fl ash.* The garage door opener lights will then indicate the current light
duration by fl ashing up to 4 times (see table below).
NUMBER OF TIMES GARAGE DOOR OPENER LIGHTS FLASH
TIME THE GARAGE DOOR OPENER LIGHT STAYS ON
To change the light duration time repeat the steps above until the lights flashes indicate your desired time frame.
NOTE: Factory setting is on.
This feature will turn on the garage door opener lights when the safety reversing sensors beam has been broken.
Deactivate: Start with the garage door opener lights off. Press and hold the LIGHT button to turn on the light, continue to hold until the light
turns off.*
Activate: Start with the garage door opener lights on. Press and hold the LIGHT button to turn off the light, continue to hold until the light
turns on.*
* Approximately 10 seconds
1. Press the LEARN button on the door control to enter Programming Mode.
2. Press the LEARN button again, the LED will fl ash once.
3. Remote Control: Press the button on the remote control that you wish to operate your garage door.
Keyless Entry: Enter a 4-digit personal identifi cation number (PIN) of your choice on the keyless entry keypad. Then press the ENTER
button.
The garage door opener lights will fl ash (or two clicks will be heard) when the code has been programmed. If programming is unsuccessful,
repeat steps 1-3 or program the remote using the learn button on the garage door opener.
Activate/Deactivate
NOTE: Factory setting is off.
Press and hold the LEARN button. Then press the LIGHT button. The service LED will fl ash the status; Activated is 2 fl ashes and deactivated
is 3 fl ashes.
1 2
1 ½ Minutes 2 ½ Minutes
6
3 4
3 ½ Minutes 4 ½ Minutes