Recessed Installation Instructions - Napoleon Alluravision Série Manuel D'installation Et D'utilisation

installation
EN

2.4.2 recessed installation instructions

Due to the many different materials used on different walls, it is highly recommended that you consult your local
builder before you install this appliance on the wall.
Select a location that is not prone to moisture and is located at least 36" (91.4cm) away from combustible
materials such curtain drapes, furniture, bedding, paper etc.
1. Measure the appliance and create a rough-in with electrical supply. The electrical junction box is located on
the left side, at the back of the appliance.
2. Remove the wall mount brackets from the back of the appliance.
3. Remove the front glass (see "front glass installation and removal" section).
4. Remove the plastic panel holding bracket by removing the screws (Fig. 2-5 & 2-6).
5. If side covers are installed prior to recessed installation, remove the side covers by removing the screws (Fig.
2-7 & 2-8).
6. Install trims (see "trim installation" section).
7. Hold the appliance up to ensure it will fit into the framing (see "framing" section).
8. Remove the power cord and complete hardwiring (see "hardwiring installation" section).
9. Use 4 screws (supplied) to secure the appliance into the wall (Fig. 2-9). Do not overtighten screws.
14
W415-2841 / F / 05.10.22
Fig. 2-5
Fig. 2-7
Fig. 2-9
Fig. 2-6
Fig. 2-8
C x 4