Connecting Water Hose To The Product; Connecting To Water Mains - Beko GN163221S Mode D'emploi

Installation
3.6. Connecting water
hose to the product
To connect the water hose to the product,
follow the instructions below.
1. Remove the connector on the hose nozzle
adaptor in the back of the product and run the
hose through the connector.
2. Push the water hose down tightly and connect
to the hose nozzle adaptor.
3. Tighten the connector manually to fix on the
hose nozzle adaptor. You may also tighten the
connector using a pipe wrench or pliers.
4. Connect the other end of the hose to the
water mains (See Section 3.7) or, to use
carboy, to the water pump (See Section 3.8).
Refrigerator / User Guide

3.7. Connecting to water mains

(Optional)
To use the product by connecting to the cold water
mains, a standard 1/2" valve connector must be
installed to the cold water mains in your home. If
the connector is not available or if you are unsure,
consult a qualified plumber.
1. Detach the connector (1) from the faucet
adaptor (2).
3
3
2. Connect the faucet adaptor to the water mains
valve.
3. Attach the connector around the water hose.
11 / 37 EN
1
2
2
1