Removing And Replacing The Warming Drawer (6650W* Model) - Samsung NE59N6650 Série Mode D'emploi

Maintaining your appliance
How to replace the door
Firmly grasp both sides of the door at the top.
1.
2. With the door at the same angle as the removal position, slide the indentation
of the hinge arm into the bottom edge of the hinge slot. The notch in the
hinge arm must be fully inserted into the bottom of the slot.
Hinge arm
Bottom
edge of
slot
Indentation
3. Open the door fully. If the door will not open fully, the indentation is not
inserted correctly in the bottom edge of the slot.
4. Push the hinge locks up against the front frame of the oven cavity to the
locked position.
5. Close the oven door.
46 English
NE59N6650W_DG68-01049A-00_EN+MES+CFR.indb 46
Hinge lock
Unlocked position Locked position

Removing and replacing the warming drawer (6650W* model)

CAUTION
Turn the power OFF before removing the warming drawer.
How to remove the warming drawer
1. Pull out the drawer until it stops.
2. Locate the locking clips near the back of each full-extension roller guide rail.
Using two hands, lift up on the left clip and push down on the right clip to
release the clips. Pull the drawer the rest of the way out.
Lever
Pull up on the left
guide
3. Pull the warming drawer away from the range.
Lever
Push down on the right
guide
2018-01-23 12:44:55