Samsung NE59N6650 Série Mode D'emploi page 51

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
Possible cause
Food does not
The serving size may not
broil properly.
be appropriate.
The rack has not been
properly positioned.
Cookware not suited for
broiling.
In some areas, the power
(voltage) may be low.
The oven
The oven sensor needs to
temperature is
be adjusted.
too hot or too
cold.
The oven will
The oven temperature is
not self-clean.
too high to start a self-
cleaning operation.
The oven controls have
been set incorrectly.
A self-cleaning cycle
cannot be started if the
oven lockout feature has
been activated or if a
radiant surface element
is on.
NE59N6650W_DG68-01049A-00_EN+MES+CFR.indb 51
Solution
Refer to the cooking guide for
serving sizes and try again.
See the broiling
recommendation guide on page
33.
Use suitable cookware.
Preheat the broil element for
10 minutes.
See the broiling
recommendation guide on page
33.
See the section on adjusting the
thermostat on page 37.
Allow the range to cool, and
then reset the controls.
See the section on self-cleaning
on page 40.
Deactivate the oven lockout
(see page 38). Make sure all
surface elements are turned off.
Problem
Possible cause
Excessive
There is excessive soiling
smoking during
in the oven.
a self-cleaning
cycle.
The oven door
The oven is too hot.
will not open
after a self-
cleaning cycle.
The oven is not
The oven controls were not
set correctly.
clean after a
self-cleaning
The oven was heavily
cycle.
soiled.
Steam is coming
When using the convection
out of the vent.
feature, it is normal to see
steam coming out of the
oven vent.
As the number of racks
or amount of food being
cooked increases, the
amount of visible steam
will increase.
A burning or oily
This is normal in a new
odor is coming
oven and will disappear in
from the vent.
time.
Solution
Press OVEN OFF. Open the
windows to rid the room of
smoke. Wait until the self-
cleaning cycle is cancelled.
Wipe up the excess soil, and
then start the self-cleaning
cycle again.
Allow the oven to cool.
See the section on self-cleaning
on page 40.
Wipe up heavy spillovers
before starting the self-cleaning
cycle. Heavily soiled ovens may
need to be self-cleaned again
or for a longer period of time.
This is normal operation and
not a system failure. Use the
oven as usual.
To speed the process, set a self-
cleaning cycle for a minimum
of 3 hours.
See the section on self-cleaning
on page 40.
English 51
2018-01-23
12:44:56

Publicité

Table des Matières
loading

Table des Matières