Johnson Pump SPX AquaT Marine Manuel D'instructions page 14

Smart Silent electric marin toilet
Mounting
Necessary items for a successful mounting are attached in a plastic bag in
the toilet box.
This assembly kit consists of:
Assembly bracket: 2 pcs
Screw Ø6,2x50: 2 pcs
Screw Ø4,7x40: 2 pcs
Washer: 2 pcs
Plastic sleeve: 2 pcs
Screw cover, chrome: 2 pcs
1. Put the toilet in the selected position.
2. Using the two holes in the toilet and the outer line of the toilet as guide,
mark the location and outer line of the bowl of the holes in the toilet.
3. Remove the bowl.
4. Re-draw a new parallel line approximately 14-15 mm inside of the line
you did in step 2.
5. Put the assembly bracket on the floor, with the slot horizontal.
6. Mark the middle position of the slot and drill a Ø5 mm hole for each
bracket.
7. Tighten the bracket by using the enclosed Ø 6,2mm screws.
(Ensure that they are not to long for your installation).
Now we recommend finishing the rest of the installation (plumbing,
electric, etc.)
8. Put the toilet back in the selected place.
9. Put the one plastic sleeve in each assembly hole on the toilet.
10. Secure the toilet by using the Ø 4,7 mm screws. As the bracket has a
lot of small holes, you can make a small final position adjustment.
11. Put the screw cover on the screw head.
12. Use the sealant around the base, towards the floor.
DETAIL A
14
A
C
B
DETAIL B
DETAIL C
Original instructions