Settings; Time Cooking; To Set Power Level; Sensor Settings - Bertazzoni MD24X Mode D'emploi

Masquer les pouces Voir aussi pour MD24X:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TIME COOKING

Your Drawer Microwave can be programmed for 99 minutes 99
seconds (99.99). Always enter the seconds after the minutes,
even if they are both zeros.
Cook for 5 minutes at 100%
1. Enter cooking time
500
2. Touch Start/Add-A-Minute pad.

TO SET POWER LEVEL

There are eleven preset power levels.
Using lower power levels increases the cooking time, which is
recommended for foods such as cheese, milk and long slow
cooking of meats. Consult a microwave cookbook or recipes
for specific recommendations.
Defrost for 5 minutes at 30%
1. Enter defrost time
500
2. Touch Power Level 8 times.
3. Touch Start/Add-A-Minute.
TOUCH POWER
LEVEL PAD
APPROXIMATE
NUMBER OF TIMES
PERCENTAGE
FOR DESIRED
OF POWER
POWER
Power Level x 1
Power Level x 2
Power Level x 3
Power Level x 4
Power Level x 5
Power Level x 6
Power Level x 7
Power Level x 8
Power Level x 9
Power Level x 10
Power Level x 11
.
.
COMMON
WORDS
FOR POWER
LEVELS
100%
High
90%
80%
70%
Medium High
60%
50%
Medium
40%
30%
Med Low/Defrost
20%
10%
Low
0%

SETTINGS

Sensor is a semi-conductor device that detects the vapor
(moisture and humidity) emitted from the food as it heats. The
sensor adjusts the cooking times and power levels for various
foods and quantities.
After the oven is plugged in, wait 2 minutes before using
any sensor setting.
Be sure the exterior of the cooking container and the interior
of the oven are dry. Wipe off any moisture with a dry cloth
or paper towel.
The sensor works with foods at normal storage temperature.
For example, popcorn would be at room temperature.
Any sensor selection can be programmed with More or
Less Time Adjustment. See page 17.
More or less food than the quantity listed in the charts
should be cooked following the guidelines in any
microwave cookbook.
During the first part of sensor use, the food name will
appear on the display. Do not open the oven or touch Stop/
Clear during this part of the cycle. The measurement of
vapor will be interrupted. If this occurs, an error message
will appear. To continue cooking, touch the Stop/Clear pad
and cook manually.
When the sensor detects the vapor emitted from the food,
the remainder of cooking/reheating time will appear. The
oven may be opened when the remaining time appears
on the display. At this time, you may stir or season food,
as desired.
Except for Popcorn, if the sensor does not detect vapor
properly when cooking other foods,
displayed, and the microwave will turn off.
Check food temperature after cooking. If additional time is
needed, continue to cook manually.
Each food has a cooking hint. Touch the Set Up/Help pad
when the HELP indicator is lighted in the display.
Some foods work best when covered. Use the cover
recommended in the charts for these foods. You may refer to
the hints by touching the Set Up/Help pad. See pages 17-18.
Casserole lid
Plastic wrap: Use plastic wrap recommended for microwave
cooking. Cover dish loosely; allow approximately 1/2 inch to
remain uncovered to allow steam to escape. Plastic wrap
should not touch food.
Wax paper: Cover dish completely. Fold excess wrap
under dish to secure. If dish is wider than paper, overlap
two pieces at least one inch to cover.
Be careful when removing any covering to allow steam to
escape away from you.
11

SENSOR SETTINGS

COVERING FOODS

will be
ERROR
E

Publicité

Chapitres

Table des Matières
loading

Table des Matières