Binder BD 56 Guide De Démarrage Rapide page 20

Quick Start Guide
Set-point entry for temperature
Back to Normal display
Confirm with OK
Enter the temperature
set-point
Check and/or adjust the safety controller (operating manual chapter 7) following any change of the
temperature set-point. The value entered as the safety controller set-point is a limit temperature, i.e.
the absolute maximum permitted temperature value.
Set the safety controller set-point by approx. 2 °C to 5 °C above the temperature set-point.
With two-door chambers ED, FD, FED 720 the maximum adjustable temperature set-point depends
on the ambient temperature.
Go to set-point entry menu
The temperature set-point flashes
BD / BF / ED / FD / FED (E3)
Display of current
temperature set-point
Go to temperature
set-point entry
Page 7