Samsung RS7 Série Mode D'emploi page 22

Remove any residual matter inside
the purifi er. (Model with the coolselect
zone)
1. Turn ON the main water supply.
2. Run water through the dispenser until the water
runs clear (approximate 3 liter).
The initial dark discoloration of water and ice is
normal
INSTALLING THE WATER
DISPENSER LINE
For Exterior model
Parts for water line Installation
Water line fi xer and screws
Water line
Connecting to the water supply line
Connect the water pipe with coupler and tap.
1. Close the main water tap.
2. Connect coupler "A" to the tap.
The water line must be connected to the cold
water pipe. If it is connected to the hot water
pipe, it may cause the purifi er to malfunction.
WARRANTY INFORMATION
This water line installation is not covered by the
refrigerator or ice maker manufacturer's warranty.
Follow these instructions carefully to minimise the risk of
expensive water damage.
Note:
If the coupler does not fi t on the current tap, go
the nearest authorized service dealer and purchase the
right couplers fi ttings.
DA68-02710R-12.indb 22 DA68-02710R-12.indb 22
Pipe connector
Purifi er lock-clip Purifi er
CAUTION
English - 22
select the location where the purifi er is to
install. (Model with the purifi er)
- If you wish to reassemble the water inlet and outlet
sides of the purifi er during purifi er installation, see
the reference illustration.
- Cut the water line attached to the purifi er to the
appropriate place after measuring the distance
between the purifi er and the cold water tap.
COUPLER "A"
LINE OUTLET
SIDE OF 90 degree
PURIFIER
PURIFIER WATER
COUPLER
WATER INLET
SIDE OF PURIFIER
TAP
CAUTION
Insert Locking Clip After Insert Locking Clip After
tube seated tube seated
Locking Clip Locking Clip
2016. 6. 22. 2016. 6. 22. 9:18 9:18