Extension Cords; Intended Uses - Work Sharp WSKTS-KO-I Mode D'emploi

Motor
Be sure your power supply agrees with nameplate marking. 230 Volts AC only
means your tool will operate on standard 50 Hz household power. Do not operate
AC tools on DC. This information is printed on the nameplate. Lower voltage will
cause loss of power and can result in over-heating.

Extension Cords

When using an extension cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized cord will cause a drop in line voltage
resulting in loss of power and overheating. The following table shows the correct
size to use depending on cord length and nameplate ampere rating. If in doubt, use
the next heavier gauge. The smaller the gauge number, the heavier the cord.
SAVE THESE INSTRUCTIONS
Volt
120V
230V
Ampere Rating
More Than Not More Than
0 6
6 10
10 12
12 16
Noise and Vibration Measurements:
Noise (measured values per EN 60745-1 and EN 60745-2-4)
A-weighted sound pressure level Lpa ........................................................................73 db(A)
Uncertainty factor K....................................................................................................3 db(A)
A-weighted sound power level Lwa ..........................................................................84 db(A)
Uncertainty factor K....................................................................................................3 db(A)

Intended Uses:

• Grinding, Sharpening and Honing applications on knives and tools.
• Light duty grinding in metal.
• Only for use with consumer applications.
• Tool should only be used with sharpening cassette installed.
Unintended Uses:
• Industrial or commercial grinding or sharpening applications.
• Extended, continuous heavy duty use.
8
Minimum Gauge for Cord Sets
Total Length of Cord in Feet
0 - 25 26 - 50
(0-7.6 m) (7.6-15.2 m)
0 - 50 51-100
(0-15.2 m) (15.2-30.4 m)
American Wire Gauge
18
18
16
14
51 - 100
(15.2-30.4 m)
101-200
(30.4-60.9 m)
16 16
16 14
16 14
12 Not Recommended
101 - 150
(30.4-45.7 m)
201-300
(60.9-91.4 m)
14
12
12