Grinding, Polishing, Deburring - Work Sharp WSKTS-KO-I Mode D'emploi

11

Grinding, Polishing, Deburring

Remove Sharpening Guide. Pull up firmly.
Ensure the Edge Guide is in the raised position and
that the Knife Sharpening Guide has been removed
before grinding.
Push Cassette Lock Release Lever to rotate cassette
to grind mode.
Use the P120 belt and high speed for light
sharpening and grinding tasks.
NOTE: Tools such as these
do not require sharpening to
a precise angle; just let the belt
conform to the edge of the tool. It will
take longer to restore an edge to
severely damaged tools.
Best Techniques:
• Always clamp or fixture work piece before grinding for optimum safety.
• Let the tool do the work. Do not overload the tool during grinding. Abrasive
selection and belt speed are already optimized.
• Only sharpen tools on the right hand / downhill side of the belt.
• Tool Grinding Attachment available for heavier grinding tasks (see Section 12).
22
Guide. Pull up firmly.
e is in the raised position and
ning Guide has been removed
elease Lever to rotate cassette
d high speed for light
ing tasks.
I I t t w w i i l l l l
o o