Troubleshooting For Users; Exceeding The Heating Period; Light Does Not Go On - Karibu 80580 Instructions De Montage Et Mode D'emploi

Instructions for installation and use

10. Troubleshooting for users

Refer to Fig. 6 (page 14).

10.1. Exceeding the heating period

Problem: "00.00" is flashing in the display 3.
Cause: After running for 6 hours, the sauna control unit automatically switches
off the sauna heater for safety reasons (heating period limit).
How to solve the problem:
To start up the sauna control unit again, press and release the time button 9.
► The sauna heater is switched on and begins to heat up.
► The display 3 and control lights 1 and 2 light up according to the operat-
ing mode.

10.2. Light does not go on

How to solve the problem:
1. Switch off the sauna control unit using the ON//OFF switch 8.
2. Switch off the main fuse of the sauna control unit in the fuse box.
3. Change the bulbs used for lighting the sauna.
4. Switch the main fuse back on.
5. Press switch 7.
► If the light still does not go on, inform customer service.
WORLD OF WELLNESS
p. 20/22