KENMORE ELITE 600 Série Mode D'emploi page 27

Gas Tank Installation
7
□ LP tank is sold separately.
□ Pull out the Gas tank Holder bracket, place the LP tank on it, connect the Regulator and hose to the tank as
shown. Then push back the Gas tank Holder.
□ Place the Gas Tank Holder on the top of the LP tank and to secure it. And fix the Gas tank Holder bracket by
inserting the bolt into the hole on the Bottom Shelf
CAUTION
Failure to install tank correctly may
allow gas hose to be damaged in
operation.
Regulator Gauge
Notice: Gauge readings may vary based on
surrounding outdoor temperature. Cold
temperature will cause reading to be slightly
lower than actual gas fill level. Warm
temperatures will cause reading to be
slightly higher.
27