KENMORE ELITE 600 Série Mode D'emploi page 13

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING
Turn controls and gas source or tank OFF
when not in use.
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Match Lighting Instructions
▲Do not lean over grill while lighting.
1.
Open lid during lighting.
2.
Place match into match holder (hanging on left side panel).
3.
Light match and insert match holder through lighting hole in
side of firebox.
4.
Place lighted match next to a burner. Turn burner knob to HI
position. Be sure burner lights and stays lit.
8.
To light the other burners repeat step 4.
9.
Once burners are lit, adjust knobs to desired flame setting. To
extinguish an individual burner, turn its knob to OFF.
Side burner Match Lighting
1. Open side burner lid.
Turn on gas at LP cylinder.
2. Place lit match near burner.
3. Turn side burner knob to HI.
Be sure burner lights and stays lit.
Burner Flame Check
• Remove cooking grates and heat diffusers. Light burners, turn
knobs from HI to LO. You should see a smaller flame in
LO position than seen on HI. Perform burner flame check
on searing burner, also. Always check flame prior to each use. If
only low flame is seen refer to "Sudden flame drop or low flame" in
the Troubleshooting Section.
Turning Grill Off
• Turn all knobs to OFF position. Turn LP cylinder off.
When you are finished grilling, raise the grill lid while allowing the grill to
fully cool. If the grill lid is closed during grill cooling, condensation may
occur on interior grill surfaces and possibly cause them to rust.
Igniter Check
• Turn gas off at LP cylinder. Press and hold electronic igniter button.
"Click" should be heard and spark seen each time between collector
box or burner and electrode. See "Troubleshooting" if no click or spark.
Valve Check
• Important: Make sure gas is off at LP cylinder before checking valves.
Knobs lock in OFF position. To check valves, first push in knobs and
release, knobs should spring back. If knobs do not spring back, replace
valve assembly before using grill. Turn knobs to LOW position then turn
back to OFF position. Valves should turn smoothly.
Hose Check
• Before each use, check to see if hoses are cut or worn. Replace
damaged hoses before using grill. Use only valve/hose/regulator as
specified in the parts list of this Use & Care Guide.
Cast Iron Grate Seasoning (if applicable)
First Use –Before first use, season cast iron grates as follows: Rinse cast iron
grates with hot water. Do not use soap. Dry grates thoroughly with a cloth
towel. Coat grates with vegetable oil or non-stick cooking spray. Place grates
in grill. Start grill and slowly raise temperature to 350° F (176.66° C) - 400° F
(204.44° C). Heat grates for one hour. Turn off grill and allow grates to cool
completely before using to cook.
Cleaning – Do not use soap when cleaning grates. Clean grates with a stiff
brush and hot water. Dry grates thoroughly with a cloth towel.
Re-seasoning – Re-season grates when rust spots appear on grate surface.
When re-seasoning grates, soap may be used with hot water to clean grates.
After cleaning, dry grates thoroughly with a cloth towel. Coat grates with
vegetable oil or non-stick cooking spray. Place grates in grill. Start grill and
slowly raise temperature to 350° F (176.66° C) - 400° F (204.44° C). Heat
grates for one hour.
Turn off grill and allow grates to cool completely before using again.
General Grill Cleaning
Do not mistake brown or black accumulation of grease and
smoke for paint. Interiors of gas grills are not painted at the
factory (and should never be painted). Apply a strong solution
of detergent and water or use a grill cleaner with scrub brush
on insides of grill lid and bottom. Rinse and allow to completely
air dry. Do not apply a caustic grill/oven cleaner to painted surfaces.
Grease Tray and Cup: Regularly clean the grease drippings from the Grease
Tray and Grease Cup. When the grill has completely cooled down after use,
remove the cup from the tray and slide the tray out of the grill. Clean the grease
drippings from the cup and tray surfaces by washing with mild
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1900752

Table des Matières