English
AUX IN to TAPE
1. Connect the 3.5mm auxiliary cable between your audio device and the Aux In
Jack of this unit
2. Press the Phono/AUX/ button to set to Aux In mode, and start playing.
3. Insert a cassette tape, and press the RECORD and PLAY button to record
the sounds from your audio device
Note: To prevent accidental recording, break off the cassette tab from side A or B.
4. To pause recoding, press the Pause button. Press it again to resume
playback.
5. To stop recording, press the Stop/Eject button.
FCC Statements
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
14