Turntable Operation; Pitch Control - Crosley CR6254A Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English

Turntable Operation

1. Rotate the On/Off Volume Knob clockwise to turn on the power.
2. Set the Function Switch to Bluetooth Output/PHONO position and the
turntable will automatically start searching for external Bluetooth speaker.
a) If you would like to play your record through the turntable's internal
speakers, continue with step 3 below.
Note: Please ensure there is no Bluetooth speaker within 30 feet working under
pairing mode to prevent accidental Bluetooth connection establishment.
b) If you would like play the record over your Bluetooth speaker, turn on the
Bluetooth speaker and set it into Bluetooth pairing mode. Once the
Bluetooth speaker is successfully paired, you will hear a short confirmation
sound from the turntable.
Note: If no Bluetooth speaker is paired with the turntable within 2 minutes, the
turntable will de-active the Bluetooth searching function and will only play the record
through its internal speakers. When you decide to connect the turntable to Bluetooth
speaker later on after the 2-minute period, you will need to turn OFF the turntable
and start over from Step 1 above.
3. Set the Speed Switch accordingly.
4. Place the record on the turntable. Use the 45 RPM Adapter if necessary.
5. Remove the stylus protector from the stylus assembly.
Note: To avoid stylus damage, make certain the included stylus guard is in place
whenever the turntable is being moved or cleaned.
6. Release the tonearm Hold Down Clip.
Note: when the turntable is not in use, remember to lock back hold down clip.
7. Lift up the Tonearm and move it over the record where play is desired to
begin. Gently put down the Tonearm and begin the playback.
8. When the record is finished playing, gently lift up the Tonearm and move it
back to the Tonearm Rest. To suspend the playback, repeat the same steps.
9. Lock the Tonearm Clip to secure the tonearm.
Platter Auto-stop
If the Auto-stop Switch is set to ON position, the platter will stop spinning
automatically when the record plays to the end. In some rare occasion, if the
turntable stops playing before the end of the record, set the switch to OFF
position the turntable should overcome this issue.

Pitch Control

The turntable speed can be increased or decreased by approximately 10% by
rotating the Pitch Control Knob. To increase the speed, turn the Pitch Control
Knob clockwise. To decrease the speed, turn the knob counter-clockwise.
6

Publicité

Table des Matières
loading

Table des Matières