Making Copies; Copy Flow - Olivetti d-Copia 120D Mode D'emploi

5
This chapter describes basic copying functions and some other copying functions.
The copier is equipped with a 1-page memory buffer. This memory allows the copier
to scan an original once only and make up to 99 copies. This feature allows for
improved workflow, reduced operating noise from the copier and reduced wear and
tear on the scanning mechanism. This feature provides for a higher reliability.
If the unit does not function properly during use, or if a function cannot
be used, see "TROUBLESHOOTING THE UNIT" (p.62).

COPY FLOW

1
Make sure that paper has been loaded in the paper tray (p.15) and
check the paper size (p.14).
If paper is not loaded, see page 15. If you are using the single bypass, check
the paper size and then proceed to the next step without loading paper.
2
Place the original.
If you are using the original table, see "Using the original table" (p.47).
If you are using the SPF, see "Using the SPF (p.48).
When copying onto A4 paper or a large size, pull out the paper output tray
extension.
3
Select the copy settings.
If you wish to copy using the initial settings (p.13), proceed to the next step.
To set the number of copies, see page 49.
To adjust the resolution and contrast settings, see page 50.
To enlarge or reduce the copy, see page 52.
To print on both sides of the paper, see page 53.
4 Start copying.
Press the start (
46

MAKING COPIES

If you are using the single bypass
) key.
Do not press the start (
sheet of paper into the single bypass.
(Page 17)
Multiple copies are not possible
using the single bypass.
) key. Insert a