Using The Scanner Mode - Olivetti d-Copia 120D Mode D'emploi

USING THE SCANNER MODE

The scanner driver for this unit includes an STI (Still image) driver and WIA
(Windows Image Acquisition) driver. You can install software that supports the STI
driver and WIA driver to enable scanning using the operation panel of the unit.
For problems with the scanner function, see the online manual or the
help file for the driver.
Using the Button Manager
Setting up the Button Manager
The Button Manager accessory software supports the STI driver and WIA driver. Setup
that is required in Windows to use the Button Manager is explained in the following.
Windows XP
1
Click the "start" button, select "Control Panel" and click
"Printers and Other Hardware", and then click "Scanners and
Cameras" in the start menu. Right click the "Olivetti d-Copia
150D" icon and click "Properties" in the menu that appears.
2
In the "Properties" screen, click the
"Events" tab.
3
Click the "Select an event" button and
select "ScanMenu SC1" from the pull-down
menu. Select "Button Manager (OLIVETTI
Personal MFP Series)" in "Start this
program" and click "Apply".
4
Repeat step 3 to set "ScanMenu SC2" through "ScanMenu
SC6".
Click the "Select an Event" button and select "ScanMenuSC2" from the pull-
down menu. Select "Button Manager (Olivetti Personal MFP Series)" in
"Start this program" and click "Apply". Do the same for each ScanMenu
through "ScanMenuSC6". When the settings have been completed, click the
"Close" button to close the screen. When the settings have been completed
in Windows, start the Button Manager. Adjust detailed settings and then
scan an image from the unit.For the procedures for starting Button Manager
and adjusting settings, see "Scan Parameter Settings Dialog Box" (p.36).
34
Olivetti d-Copia 150D Properties
Button Manager (Olivetti Personal
Olivetti d-Copia 150D Properties
Button Manager (Olivetti Personal