GRE HPM20 Manuel D'instructions page 11

SAFETY INSTRUCTIONS. READ CAREFULLY
• All electrical installations should comply with the following standard;
NF C15-100
NF EN 60-335-2-41
that refers "to the construction of electrical installations, both in indoor and outdoor swimming pools", or the equivalent standard
in force in each region or country.
• All heat pump should follow the C 15-100 installation standard that stipulates that all electrical apparatus located at less than
3.5 m. from the pool and freely accessible, should be supplied by a very low voltage of 12 V. All apparatus supplied with 220 V
should be located at least 3.5 m. from the swimming pool edge. Ask the manufacturer for permission to make any modifications
in one or more elements of the heat pump system.
• The electrical installation should be performed by professional staff qualified in electricalinstallations.
• Do not operate the apparatus unless it is properly installed.
• NEVER touch the heat pump when it is operating if you are wet or have wet hands.
• When you want to open the cabinet of heat pump, DISCONNECT the power supply.
• Make sure that the ground is dry before touching the electrical equipment.
• Do not allow children or adults to lean against or sit on the apparatus.
• If the supply flex of the apparatus is damaged, it should be replaced. Read the instructions carefully to replace it.
If in doubt, contact the technical service.
8