Drive Belt Replacement - RIDGID K-60SP Mode D'emploi

K-60SP Drain Cleaning Machine
Figure 11 – Remove Socket Head Cap Screws
2. Remove the jaw housing. The clutch jaw assembly is
contained in the jaw housing.
3. Remove the jaw set cover by rotating counter-clock-
wise (Figure 12).
Figure 12 – Remove Jaw Set Cover
4. Clean the clutch jaw assembly, jaw cover, and the in-
side of the jaw housing.
5. If worn, replace the clutch jaw assembly.
6. Reinstall the jaws into the jaw housing and replace the
jaw set cover.
12
7. Rotate the adjustment knob clockwise until the jaw set
touches the jaw set cover. This will in sure that the jaw
set is properly aligned.
8. Attach jaw housing to machine with socket head cap
screws.
NOTE! Make sure flanges on plastic shroud are con-
tained inside the jaw housing.

Drive Belt Replacement

1. Stand the machine up on the front of the frame.
Make sure clutch handle is in its uppermost posi-
tion. Remove the two (2) socket head cap screws
from the jaw housing with a
2. Remove the jaw housing.
3. Loosen the jam nut on the side of the machine
(Figure 13).
4. Rotate motor adjustment set screw counter-clock-
wise with 3 / " hex key until belt is loose enough to be
16
removed.
Figure 13 – Loosen Jam Nut
5. Install new belt and set unit down on bottom of frame
(operating position), so belt will become tensioned by
the weight of the motor.
6. Rotate the motor adjustment set screw until it just
touches the motor. Once the set screw touches
motor, rotate set screw
1 / " hex key. (Figure 11)
4
1 / turn clockwise.
2
999-997-050.10_REV. A