Kerbl EcoKill 299950 Mode D'emploi page 7

3.3.1. The device is put in place
Make sure that the underground is even and dry and that no easily ignitable objects are in the immediate vicinity of the device. The
site of installation should likewise be beyond the reach of children. For smooth functioning it is important that the device is
set up so that insects can fly unimpeded toward the light from both sides. Other sources of light and drafts have a
negative affect on the effectiveness of the UV light.
3.3.2. The device is suspended
Choose the site with care. Other sources of light and drafts have a negative affect on the effectiveness of the UV light. Make sure
that the chains are firmly attached to the device. Install the insect killer between 1.5 und 3.0 m above the ground.
Caution: Do not hang outdoors! The device is for indoor use only!
3.4. Servicing
3.4.1. Cleaning
Switch the device off and pull the power plug before cleaning. Empty the drip pan on a
regular basis. When doing this, pull it carefully out of the housing. The pan can then be
rinsed with water. Let it dry before reinserting. The protective screen, the high-voltage
screen and the UV lamps can be cleaned with a dry cloth or with a brush.
3.4.2. Exchanging the lamps
Before exchanging the lamps, switch the On/Off switch to "Off" and pull the mains plug.
Remove the drip pan. Now unscrew the two top screws on both side sections. Remove
the side sections by pulling them down. Now flip the protective screen to the front.
Remove the lamp(s) carefully from the socket and insert the new lamp(s). Carefully close
the housing again.
Danger, high voltage: Do not re-plug into the power source until reassembly is com-
plete!
3.4.3. Exchanging the starters
Before exchanging the starters, switch the On/Off switch to "Off" and pull the mains plug.
Remove the drip pan. Now unscrew the two top screws on both side sections. Remove
the side sections by pulling them down. Now also remove both side screws in order to
dismantle the lid. Remove the lid. By turning the starters they can easily be exchanged.
Insert the new starters and affix them by turning slightly. Seating is correct when you
hear them snap (click) into place. Carefully close the housing again.
Danger, high voltage: Do not re-plug into the power source until reassembly is com-
plete!
4. Alternative tubes
#299811 15 Watt
5. Specifications
Mains voltage: 220 - 240 Volt
Frequency: 50 Hz
Power: 37 Watt
High voltage: 2.200 Volt
Effective range: max. 150 m2
Electrical waste
It is up to the operator to dispose of the device responsibly after its useful life in accordance with local regulations. Consult the relevant regulations for your
country. The device must not be disposed of in household waste. Under the terms of the EU Directive on the disposal of old electrical and electronic equipment,
the device can be taken to local authority-run refuse sites or recycling plants free of charge, or returned to dealers who offer a returns service. Correct disposal
protects the environment and prevents any possible harmful impacts on humans and the environment.
This device must not be used by individuals (including children) with impaired physical, sensory or mental abilities or those with insufficient experience and/or knowledge
to do so, unless they are being supervised by someone responsible for their safety or are receiving instructions from someone on how to use the device. Children should be
supervised at all times to ensure that they do not play with the device.
7
Fig. 1
Fig. 2