1.
IMPORTANT WARNINGS
•
If the device is stored prior to installation, store it upright in a well ventilated area.
•
In the event that the device is stored or transported in a horizontal position, place it upright for 24
hours before installing and commissioning.
•
The heat pump must be installed by a qualified professional according to the instructions provided.
•
Any interventions on the refrigerant circuit of the device must be carried out by a company certified
to handle refrigerants by an approved organisation.
•
The refrigerant circuit carries R32, which is inflammable.
•
The device must be wired in by a qualified electrician according to the rules of the art and the
regulations in effect in the country of installation.
•
The distance between the device and the pool must respect the rules of the art and the regulations
in effect in the country of installation. In France, the standard NF C15-100 requires that the heat
pump be positioned outside the hatched area in the diagram below:
•
The power line of the device must be fitted with a means of deenergising all active poles (live and
neutral) upstream from the heat pump so that it may be systematically deenergised before any
technical intervention.
•
Upon installation, carry out the hydraulic connections before wiring in the device. To dismantle the
heat pump, proceed in the reverse order.
•
This device may be operated by children less than 8 years of age and persons with reduced
physical, sensory or mental capacities, or lacking experience or knowledge, if they are correctly
supervised or if the instructions concerning safe use of the device have been explained to them
and they have understood the risks involved. Children should not be allowed to play with this
device. Children should not be allowed to clean the device without proper supervision.
•
If the power line is damaged, it must be immediately replaced by the manufacturer, its after sales
service or a similarly qualified person.
•
Never push any object through the grating protecting the fan as this could cause damage to the
fan.
•
Never switch the heat pump on if the fan's protective grate is missing.
•
Always cut the power supply to the heat pump upstream before any intervention requiring opening
of the casing or any intervention on the hydraulic connections.
•
Cut the power supply to the heat pump during storms.
BWT MINI-HEATER
2019/02 - Indice de révision : A - Code : 33290
15/36