FAAC XP 15 W Manuel D'utilisation page 10

Whilst the channel set is being displayed, the
pair of photocells is inactive and its contact is
therefore OPEN. Wait for the end of the display
to operate the automated system.
CHECKING THE INDICATOR LEDS FOR THE RX
The states and significance of the LEDs on the Receiver are
shown below; refer to figure 8 to find their position.
DL 1 Power supply
ON Power on
OFF Power off
DL 2 Transmission channel and charge of the TX battery
ON TX Battery OK
Slow
Indication of transmission channel
flashing
Rapid
TX Battery almost discharged
flashing
TX battery flat or
OFF
Photocell engaged
DL 3 Alignment
ON Alignment OK
Slow
Alignment not correct
flashing
Non-alignment or
OFF
Photocell engaged
6. TROUBLESHOOTING
Help with the identification and resolution of particular conditions regarding operation of the photocells is given
below.
For a complete list of the error/breakdown situations, refer to the
application.
CONDITION
The gate does not move. The
DL2 and DL3 Receiver LEDs are
off.
The DL2 Receiver LED flashes.
The DL3 Receiver LED flashes
CAUSE/PROBLEM
- Non-alignment
- The Transmitter is not receiving
power
- Incorrect choice of transmission
channel.
Incorrect power supply to the
Transmitter.
The photocells are not correctly
aligned.
8
CHECKING THE INDICATOR LEDs FOR THE TX
The states and significance of the LEDs on the Transmitter
are shown below; refer to figure 9 to find their position.
DL 1 Power supply
ON Mains power supply on
OFF Mains power supply off, battery operation
DL 2 Transmission channel
OFF Normal Operation
Slow
Display of the transmission channel
flashing
Complete the installation by closure of the photocells
just installed with the appropriate four-screw closing plug,
being careful to position the rubber separator (indicated
in figs. 2, 3 ref. ) so as to ensure the correct degree of
IP insulation
instructions for the control unit used to move the
- Check the selection of the transmission
channel.
- Check the power supply to the pair of
photocells.
- Check the alignment of the pair.
- Replace the battery inside the Transmitter.
- If the Transmitter is mains powered, check
the voltage.
- Adjust the alignment of the photocells.
SUGGESTION