Operation - Ryobi P2905 Manuel D'utilisation

WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power head until assembly is complete.
Failure to comply could result in accidental starting and
possible serious personal injury.
INSTALLING THE WIRE BRUSH AND
DEFLECTOR ASSEMBLY
See Figure 2.
 Insert the wire brush and deflector assembly into the base
as shown and push until the latch clicks into place. Check
to be sure it is securely locked into position.
NOTE: The brush will fit in only one position. If it isn't
locking into place, turn the assembly head over and try
again.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1 along with hearing and breathing
protection. Failure to do so could result in objects being
thrown into your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
ASSEMBLY
 To remove, push the latch and pull the assembly away
from the base.
INSTALLING THE WHEEL END CAP ASSEMBLY
See Figure 3.
The wheel end cap assembly is provided to assist in moving
the patio cleaner – wire brush across the surfaces.
 Insert the wheel assembly into the base as shown and
push until the latch clicks into place. Check to be sure it
is securely locked into position.
NOTE: The assembly will fit in only one position. If it isn't
locking into place, turn the assembly over and try again.
ATTACHING THE FRONT HANDLE
See Figure 4.
The front handle must be used to ensure the best control and
maximize operator safety when using this product.
 Loosen and remove the wing nut and bolt from the handle.
 Install the handle on the power head shaft at the location
indicated by the label on the shaft.
 Adjust handle up or down, if necessary, to desired operat-
ing position.
 Reinstall the bolt and wing nut. Tighten wing nut to secure.

OPERATION

WARNING:
Do not allow hands, feet, or any other part of the body
or clothing near the rotating brush or any other moving
part. The brush will rotate once the lock-out button is
depressed and switch trigger is pulled. The brush contin-
ues to rotate until the switch trigger is released. Failure to
avoid contact could cause serious personal injury.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts are
replaced. Please contact customer service or a qualified
service center for assistance.
7 — English