CWT CALMAT PLUS Mode D'emploi page 9

2) Now place the red impulse cable in the left socket
(4). Feed the cable to the back of the pipe and fasten
with a cable tie. Wind the cable tightly and firmly
around the pipe to create a coil. Plug the second
impulse tie through the black loop at the end of the
cable and fasten it.
3) Repeat the installation with the other impulse
cables again (see 2.).
4) First connect the adaptor (5) with the electronic unit
with the socket on the left site of the device. Plug
the mains plug into the power socket (permissible
voltage: 100 - 240 V, 50/60 Hz). The green control
light (3) will light up. The display will show: calmat
5) Set up your program
Please choose your language with the upper button
( ). Then press the button (P) to select the program
according to your pipe material and pipe diameter
(a,b,c, or d). You can change the programme selection
at any time later.
2a Metal pipe
2b Metal pipe
2c Metal pipe
2d Plastic pipe
2e Plastic pipe
2f Plastic pipe
Final check
The electricity supply is indicated by the green control
light (3). The display shows the activated program.
Ø max 2"
Ø max 2 ½"
Ø max 3"
Ø max 2"
Ø max 2 ½"
Ø max 3"
CONTENTS
1 Electronic unit
1 Power adapter
4 Impulse cable
12 Cable binders
1 Instruction manual
1 Warranty card
CWT hereby declares that this product is in accordance with the
following EU-guidelines: 73/23/EG; 89/336/EG which is certified by
the CE-mark.
The equipment corresponds to the requirements of the German
Industrial Safety Act and the European low-voltage guidelines. This
is certified by the GS-mark of the independent testing institute.
9 9
GB GB