Operation; Powering Up Light Source; Light Brightness Control; Cleaning - Cuda Fiberoptics MD-150T Manuel D'utilisation

6. OPERATION

6.1 POWERING UP THE LIGHT SOURCE
To operate the light source: Attach the light source to the instrument or headlamp.
Turn on the power switch. The fan and lamp will start.
Each power switch controls the individual lamp as marked, i.e., Lamp 1, Lamp 2

6.2 LIGHT BRIGHTNESS CONTROL

The light brightness adjustment enables the user to obtain a brighter or darker
illumination of the object of observation.
Adjust the light intensity by turning the intensity control knob.
Each lamp has its own control as marked

7. CLEANING

NOTE Always disconnect the power cord before cleaning the system.
The control unit can be cleaned with any cleaning agents used for external cleaning of
electric equipment, according to instructions given by the manufacturer of the cleaning
solution.
Do not allow excessive moisture or liquids to come in direct contact with the control unit.
Do not use cleaning agents that are not permitted for use with plastics, i.e., ammonia,
acetone, salty acids (HCl), etc.
Do not allow cleaning agents or liquids to enter the control unit outlets.

8. DISINFECTION AND STERILIZATION

8.1 DISINFECTING THE UNIT
NOTE Always disconnect the power cord before cleaning the system.
Use any disinfectant agents which are commonly applied while disinfecting surfaces of
electric medical equipment. Such disinfectant agents usually arrive in the form of
sprays or damp cloths.
Follow the instructions given by the manufacturer of the disinfectant solution.
8.2 STERILIZING THE LIGHT CABLE
The light cable should be sterilized according to the sterilizer manufacturer's
specification.
LIT046 CUDA
(English)
Rev. E
Page 9 of 60