Specifications; Operation; Battery Replacement - Cuda Fiberoptics LED Rover Mode D'emploi

4

SPECIFICATIONS

.
Item
Lamp Type
Color temperature
Lamp life
Battery (2X)
Current converter output
Discharge time
Dimensions
Weight
Classification

5. OPERATION

The LED Rover is operated by a pushbutton switch inside a protective
silicone rubber boot at the back end of the handle. It features a momentary
ON function with partial depression of the switch, and clicks to stay ON with
full depression. Depress the switch fully again to turn it off.
6.

BATTERY REPLACEMENT

Unscrew the headpiece that houses the LED. (Do not remove the switch; the
batteries cannot fit through the switch end.)
insert the new ones. Observe correct polarity. The positive (+) end of both
batteries must point toward the headpiece. The positive end of the battery
has a protruding nipple; the negative (-) end is flat.
NOTE: Because discharge characteristics may vary between designations or
between used and unused batteries, always replace batteries in pairs with
pairs of identical new batteries.
Replace disposable 3 volt Lithium CR123 primary batteries only with similar
size and voltage batteries.
Rechargeable batteries RCR123A may also be used.
"RECHARGEABLE
rechargeable batteries. Rechargeable batteries may be used in any Rover
originally supplied with disposable primary batteries, and vice versa.
Storage: Store in a dry area at 40º F – 85º F.
®
LIT102 CUDA
(English)
Specification
Luxeon 3-Watt LED
5500K (nominal)
100,000 hrs. (nominal)
Lithium CR123, 3Volts or Lithium ion RCR123A, 3.6V
611milliamps (nominal)
110 minutes (typical, actual endurance may vary)
5 inches long X 1.25 inches diameter at LED housing
.2 lbs. (3 ¼ ounces)
FDA Class I (for ENT use only)
BATTERY MODEL"
Remove the old batteries and
See Section 7
for more information about
Rev. I
Page 5 of 35