Battery Charger Safety; Technical Data - Beta 1498/2A Mode D'emploi

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO

BATTERY CHARGER SAFETY

• Before use, check that the battery charger has not been damaged, and that there are no uncovered
cables or worn parts.
• Do not use the device when damaged, to avoid the risk of electric shocks; do not try to open or modify it.
• Do not damage the electronic circuit of the battery charger.
• Connect the charger to the mains power supply, making sure that the mains voltage
matches that stated on the power supply device (See TECHNICAL DATA table).
PERSONNEL SAFETY
• Stay alert; watch what you are doing. Do not use the device while tired or under the influence of drugs,
alcohol, or medications
• Always use the following personal protective equipment:
• safety shoes
• eye protection
• protective gloves against physical agents.
• Use the battery charger in well-aired, dry rooms.
• Before connecting the cables to the battery or disconnecting them, make sure that the device is not
connected to the mains.
• Never allow the clips of the clamps (positive-red and negative-red) to touch together.
• Check that the cables of the battery charger are kept away from fans, moving parts and the fuel pipe.
• Do not wear loose clothing, jewellery or metal objects when working on the vehicle.
• Before replacing the battery charger, make sure that it has cooled down and reached room temperature.
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING DEVICE
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR SAFETY SHOES
ALWAYS USE PROTECTIVE GLOVES AGAINST PHYSICAL AGENTS WHILE OPERATING DEVICE
ALWAYS WEAR EYE PROTECTION
Additional personal protective equipment to wear according to the values found in the
environmental hygiene/risk analysis survey if the values exceed the limits under current
regulations.

TECHNICAL DATA

FOR USE WITH BATTERIES
CHARGING CAPACITY
CHARGE HOLDING CAPACITY
POWER SUPPLY VOLTAGE
OPERATING TEMPERATURE
DEGREE OF PROTECTION
DIMENSIONS
WEIGHT
12V
2Ah ÷ 40Ah
2Ah ÷ 100Ah
220-240V ~ 50/60Hz
-10°C +40°C
IP65
180x80x40 mm
0.5kg
EN I
9